|
#1
|
||||
|
||||
Quote:
my inquiry is about the noise
__________________
180G in the making, miracle 72x24x24 lights by slifigoi 3x400w 8x39w 72inches water movement by tunze LPS dominant mixed reef |
#2
|
|||||
|
|||||
The QD's are quieter than the older WES model. I just installed a QD driver on my 1 year old dryside and wetside. I measured it to be 7 dB quieter. The thread is in the equipment section somewhere.
|
#3
|
||||
|
||||
if sound level is your greatest concern, Vortechs are not for you...
You will find that they are very loud. if you really need quiet, look at Tunze's instead... |
#4
|
||||
|
||||
Or if you plan on running an Apex controller these new Neptune WAV pumps should be out very soon and they look really promising.
http://www.neptunesystems.com/wav/ I think ill be grabing a pair. |
#5
|
||||
|
||||
I agree, you will always get some motor sound, if you must have a controllable wave maker you might consider Jebao RW's
__________________
220Gal Dining room build complete! no bucket or barrel water changes!!! |
#6
|
|||||
|
|||||
Quote:
If you want dead quiet, VorTechs may not be the choice for you. I suggested 2xMP40 because with your size tank, you'll have a ton of options & flow while running them at a lower speed. In my experience with my non QD versions, they are barely audible up to about 50%. If you want to make a large wave, then you need to run them in short pulse mode up to almost maximum speed and that will drive you nuts long term, so not a good way to run them constantly. If you run them in TSM limited to 50%, you'll barely know they are running, provided you get them aligned properly. Here's a link to a post from another thread where I provide a bit of history on my experience with VorTechs. http://www.canreef.com/vbulletin/sho...5&postcount=12
__________________
Mike 77g sumpless SW DIY 10 watt multi-chip LED build http://www.canreef.com/vbulletin/showthread.php?t=82206 Last edited by mike31154; 05-29-2015 at 12:02 AM. |