#21
|
|||||
|
|||||
Quote:
My MP10 was dead quiet IMO vs my Mp40's with the new quiet drive.... I don't think you would have any regret. Also having control via apex with the add on module is really handy. I'd get the MP10 IMO
__________________
|
#22
|
||||
|
||||
If the wires inside the tank don't bother you too much, the Tunze's are practically silent. I have an MP10Wes and I'm going to upgrade it with the new QD driver. It's wonderful not having the wires in the tank and also the low profile up against the glass. However I doubt anything would get it as quiet as the Tunze if noise is of major concern. I have several Tunze's and they are all dead quiet. I'd also like to check out the gyre in person at some point. Was hoping J&L would have it set up at some point too.
|
#23
|
||||
|
||||
Thanks everyone for your input, after lots of reading reviews and talking to others, I stopped in at J&L and picked up a Vortech MP10QD today, hopefully I'll get it installed tomorrow.
Looking forward to see how it works out.
__________________
Hey! I never "LEFT" the hobby, just doing fresh water now. Which is still listed as part of Canreef if I'm not mistaken. |
#24
|
||||
|
||||
Well now you have to report on your good or bad experience with said powerhead. Good luck and enjoy.
|
#25
|
||||
|
||||
Quote:
It's virtually dead silent unless you put your ear right up to the motor and there's a slight hum, this new driver it comes with does a great job.
__________________
Hey! I never "LEFT" the hobby, just doing fresh water now. Which is still listed as part of Canreef if I'm not mistaken. |
#26
|
|||||
|
|||||
Quote:
P.S. Don't forget the Tunze! |