|
|
|
|
|
#1
01-24-2012, 01:33 AM
|
|||||
|
|||||
Reheating Tank
My power was out for this morning while i was at work. It sucked. I knew it was out from the start, and my work doesn't allow fish days, so i was dreading it all day. My controller never came back online, so i was worried. Got home and... both GFCI's tripped when stuff re-started, so my tank was un-powered for 12 hours. Tank temp is 73 degrees, i have my halides on, 3x250W heaters on, and trying to get it up. I've got all my powerheads at the surface sucking air bubbles into the tank to help with O2.
Is there an issue re-heating too fast? Temp swings are bad, i just want it in a normal range so i can hopefully save whats left. Should i blast this up to 75-76 then slow it down? or just ease it up the whole way? So far: flame hawkish, coral beauty, shrimp, bunch of hermits, all dead. Coral is an unknown right now, but not looking terrible, i'll have to see what happens in the next few days. My tang is having a rough time, on the sand gasping.
__________________
My 150 In Wall Build 
|
|
#3
01-24-2012, 01:45 AM
|
|||||
|
|||||
|
Quote:
Take the tang out and any other fish who are suffering and place it is a large container with tank water and place a bubbler in the container. The deaths are the result of lack of oxygen.
|
|
#4
01-24-2012, 01:58 AM
|
|||||
|
|||||
|
Thanks all, the fish all seems to be doing well now, even the tang is swimming around being a bully as usual. I thought he was for sure dead after seeing him unable to move when i poked him. The fox face is usually the first to show stress and starts looking like he's been dead for a month and molding, but he's back to his usual yellow color.
I think everything should end up working itself out... except I've noticed a LOT of dead pods in my tank, so i foresee a large nitrate cycle in the next few days :S. Good thing i'm off work now for a bit and can hopefully help this out.
__________________
My 150 In Wall Build
|
|
#5
01-24-2012, 02:06 AM
|
|||||
|
|||||
|
It'll take a while for the tank to heat up anyway so I wouldn't be concerned about heating it up too fast.
See if you can setup your controller with black out delays at different intervals for various equipment, that way everything won't attempt to turn on at once and trip breakers/GFCIs. I personally don't run my return pump and controller power through a GFCI, everything else yes but the controller doesn't need it and the return pump is just too important. Best of luck.
|
|
#6
01-24-2012, 02:16 AM
|
|||||
|
|||||
|
Sphelps.... if you only knew
 , this is SO bad, my controller is set up to do all of that, and i was at HD the other day and picked up everything i needed to finish off re-doing power outlet part of my controller so that i could put everything back on there instead of my temporary timers. Well.. i was tired last night and went to bed early instead of doing it... and so now while i monitor the tank i'm setting it up so this doesn't happen again. I swear, the fish gods knew i just spent my fish tank budget on a lighting upgrade, and i was too lazy to finish my timer. This is how they punish me.
__________________
My 150 In Wall Build
|
Hybrid Mode
