Canreef Aquatics Bulletin Board  

Go Back   Canreef Aquatics Bulletin Board > General > Reef

Reply
 
Thread Tools Display Modes
  #11  
Old 02-18-2006, 06:08 AM
Myanth Myanth is offline
Member
 
Join Date: Jan 2006
Location: Edmonton
Posts: 119
Myanth is on a distinguished road
Default

okay... so the 170 KH is listed as mg/L. So is the cacium. It is a nutrifin test kit and it says optimal level of Ca is 400-425, I know alot of people are 450-475, and the optimal KH is 105-120 mg/L.

I have added Seachem calcium, powdered, at a rate of 7.5g/40gal. It says that it will raise Ca 18mg/L with each 5g/40gal dose, so I should get a little more increase than that. The maximum daily dose is 10g/40gal. I have mixed up enough top off water to last ten to eleven days at a rate of 7.5g/40gal. I should, after that period be somewhere in the 400 range.

Is this too quick an increase? Should I dilute? And where should the KH really be?

I was going by this test kit and no other knowledge. Since my questioning of it I have seen numbers ranging from 100 - 350. Bev... Ruth? Shine some brilliance on me.

Thanks
Mike
__________________
This all started with a ten gallon and two clowns.
Reply With Quote
  #12  
Old 02-18-2006, 10:39 AM
Ruth's Avatar
Ruth Ruth is offline
Member
 
Join Date: Jul 2005
Location: Fort St. John, British Columbia
Posts: 1,605
Ruth is on a distinguished road
Default

You should reveiw Bev's chemistry links that are a sticky in this forum to fully get the whole picture. I like to try to keep my levels at close to NSW (Natural Sea Water) so here is what I try to shoot for - a little more or less is not that big of a deal:
Alk - 2.9 meg/L or KH of 8 dKH
Calcium - 400 - 425 ppm
Magnesium - 1300-1500ppm

I have always used Salifert test kits to test the majority of my levels in my aquariums. They are easy to use and from what I have read fairly accurate. The only one that I am convinced is not very accurate is the Phosphate test kit.

As with everything in this hobby good things happen slowly and bad things happen quickly.

If I was you I would be tempted to either take a sample of your water into a LFS to have it tested or to a friend that has all 3 of the above test kits to double check for accuracy. See where you are at with all 3 and then go from there - slowly adjusting, testing and re-testing. Over the course of a week or two you should be able to adjust.

I can't remember what size of a system you are running but if it is not that big the easiest thing to do may be to just do a few large (50%) water changes.
HTH
Reply With Quote
  #13  
Old 02-18-2006, 12:18 PM
Johnny Reefer's Avatar
Johnny Reefer Johnny Reefer is offline
Member
 
Join Date: May 2005
Location: Victoria, B.C.
Posts: 1,192
Johnny Reefer is on a distinguished road
Send a message via MSN to Johnny Reefer
Default

Quote:
Originally Posted by Myanth
.... Using Nutrifin test kit where you add drops and multiply result by 10. took 17-18 drops to get the lime colour. ....
Mike
Hagen kits work the same way. But there is one more step. The kit provides conversion formulas. Multiply that number by 0.056 for dKH. Multiply by 0.02 for meq/l.
170x0.056=9.52dKH.
170x0.02=3.4 meq/l.

I'd say your alk is fine, IMHO.

HTH and cheers,
__________________
Mark.
Reply With Quote
  #14  
Old 02-18-2006, 03:57 PM
Myanth Myanth is offline
Member
 
Join Date: Jan 2006
Location: Edmonton
Posts: 119
Myanth is on a distinguished road
Default

Found it! Thanks.

The conversion table is in the freshwater section. Didn't see it till this morning.

multiply my 170 reading by 0.056 = dH, 0.07 = Clark H, 0.1 = fH, 0.02 = mEq/L

so I guess I am at 3.4 mEq/L or 9.52 dH in degrees? looks like a degree sign next to it.

Cool. Is this too hard? I'll aim for 2.9 mEq, both the mag and calcium suppliments say that they can lower hardness slightly. I'll get the Ca up and retest.

Thanks all
Mike
__________________
This all started with a ten gallon and two clowns.
Reply With Quote
  #15  
Old 02-19-2006, 07:10 AM
Snappy's Avatar
Snappy Snappy is offline
Member
 
Join Date: Jan 2005
Location: Calgary, Alberta
Posts: 4,675
Snappy is on a distinguished road
Default

Mike,
I personally recommend the WM Research products like "Reef Pure". I use the liquid concentrated calcium and their powdered PH and KH buffers. Once you have the desired levels you can use their 2 stage additives to help lock it in and IMO they work well.
__________________

Greg
Reply With Quote
  #16  
Old 02-19-2006, 12:57 PM
medican's Avatar
medican medican is offline
Member
 
Join Date: Apr 2004
Location: Airdrie
Posts: 203
medican is on a distinguished road
Wink Math Time....hehe

ok.....

The drops 17-18

I think you have multiplied that by 10......hence 170 that is mg/l or ppm these 2 are the same thing.

dKH is the German reading I think most saltys use this (could be wrong there...lol)

Lets start at the drops.......

17x10=170
17.85 is a factor
170/17.85=

9.52dKH

now thats not bad at all....IMO

The next one is your Mg I dont think you can move forward untill you know what readings you have.

good luck

P.S. GH is for fresh.......KH is for salt
__________________
Richard
_______________________________________
My wife believed me when I told her it was only going to cost about $500.00. that was over two years ago and I'm still grounded.....
Reply With Quote
  #17  
Old 02-19-2006, 02:04 PM
mr_alberta's Avatar
mr_alberta mr_alberta is offline
Member
 
Join Date: Apr 2003
Location: Edmonton, AB (University Area)
Posts: 2,506
mr_alberta is on a distinguished road
Default

Holy cow! People still do math!?

http://www.hagen.com/usa/aquatic/gh_kh_conv_cal.cfm
__________________
32"x32"x20" Cube-ish tank
Reply With Quote
  #18  
Old 02-19-2006, 02:15 PM
Beverly's Avatar
Beverly Beverly is offline
Member
 
Join Date: Mar 2003
Location: North Edmonton
Posts: 3,560
Beverly is on a distinguished road
Default

Quote:
Originally Posted by mr_alberta
Holy cow! People still do math!?
Math is good Math is your friend Just keep one of those old fangled calculators on hand. Mine runs when the light is on
__________________
Beverly
~~~~~

Beverly's 10g Nano YouTube Channel
Reply With Quote
  #19  
Old 02-19-2006, 02:28 PM
mr_alberta's Avatar
mr_alberta mr_alberta is offline
Member
 
Join Date: Apr 2003
Location: Edmonton, AB (University Area)
Posts: 2,506
mr_alberta is on a distinguished road
Default

Quote:
Originally Posted by Beverly
Just keep one of those old fangled calculators on hand. Mine runs when the light is on
One of these?
__________________
32"x32"x20" Cube-ish tank

Last edited by mr_alberta; 02-19-2006 at 02:30 PM.
Reply With Quote
  #20  
Old 02-19-2006, 02:36 PM
Beverly's Avatar
Beverly Beverly is offline
Member
 
Join Date: Mar 2003
Location: North Edmonton
Posts: 3,560
Beverly is on a distinguished road
Default

Hey, I'm old, but not that freaking old More like this and it was cheap, too

__________________
Beverly
~~~~~

Beverly's 10g Nano YouTube Channel
Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT. The time now is 11:08 PM.


Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.