|
|
|
#11
11-13-2005, 02:22 PM
|
||||
|
||||
Sounds like the box then.
It just surprises me that the box at 5x5 would restrict the flow that much. Call me if I can help. Wendell 
|
|
#12
11-13-2005, 04:20 PM
|
|||||
|
|||||
|
Are the boxes 2 sided corner overflows ? or centered 3 sided ?
Im guessing the spacing between the teeth is the problem. They wouldnt happen to be a "saw blade" width slots would they ?
__________________
Confucious say : Things that come to those who wait, will be things left over by those who didnt.
|
|
#13
11-13-2005, 05:07 PM
|
||||
|
||||
|
Fudge, the teeth are 5/16" and the box is 2 sided. I have fixed the problem and now it works fine. I have used a high speed rotary saw (big dremel) and cut the top of the box off 3/4" below the bottom of the teeth. I then glued the removed L shaped peice to the outside of the box. This lowered the top of the teeth 3/4" and provided an extra 1/2" of lip length per box. The extra 1" total lip and the lowered box height seem to handle the flow now. For those looking at adding boxes to their tanks I can say that the calculator on reefcentral for overflow length is a good starting point. It recommends 23" of total overflow length for 1500 gph. I had 22 and the water was just cresting the top of the teeth. I now have 23 and the flow is just below the top.
http://www.reefcentral.com/calc/drai...0&drain=Submit Thanks for all your help and tips. 
|
Linear Mode
