![]() |
#11
|
|||||
|
|||||
![]() So its been just over a week of running this skimmer. Im still trying to find the skimmer sweet spot tho. It is still skimming a bit on the wet side. Im gonna try running it in 8 1/2" of water this weekend and see how that works. I am still very impressed with the power of this pump! nothing gets by it
![]() ![]()
__________________
60" 120G project-DONE!!!! |
#12
|
|||||
|
|||||
![]() So the skimmer is now been running in 8 1/2" of water since sunday afternoon. So far so good! its skimming a bit on the wet side but I turned it down a little bit and emptied the skimmer cup and will update in 24hrs.
Cheers Ray 24hrs at 8 1/2" ![]()
__________________
60" 120G project-DONE!!!! |
#13
|
|||||
|
|||||
![]() the skimmer is performing great but im still not getting that thick stinky foam that i like so much lol I was trying to think why in comparison with the nac7 i am not getting it. The nac7 had a mesh wheel impeller compared to the 180s needle impeller. I am thinking of doing the mod but do not want to attempt it without any spare parts for the aquabee lol just in case cause I am know to breeak things with my stone hands lol. I am only doing this mod out of personal preferance.
Cheers Ray
__________________
60" 120G project-DONE!!!! |
#15
|
|||||
|
|||||
![]() I wont be doing the mod for a while. probably do it in just over a month or so
__________________
60" 120G project-DONE!!!! |
#16
|
|||||
|
|||||
![]() Just a side note, a mesh wheel is available it is an option from Bubble magus
![]() Just ask your retailer for one. |
#17
|
|||||
|
|||||
![]() on the weekend I made a eggcrate stand for the skimmer and its now sitting in 8" of water and is running like a dream! The outflow knob is dialed in a 3.5(out of 6) Im staring to get that thick foam ive been looking for
![]() Cheers Ray
__________________
60" 120G project-DONE!!!! |
#18
|
|||||
|
|||||
![]() This skimmer is getting better by the week
![]() Cheers Ray ![]() ![]() ![]()
__________________
60" 120G project-DONE!!!! |
#19
|
|||||
|
|||||
![]() Interesting to know, where did you set the skimming water level?
Inside the neck or just below the neck? If inside the neck how far up? I am running the BM-150Pro (uses the same pump) and with ultra low nutrients its still pulling Poo daily ![]() |
#20
|
|||||
|
|||||
![]() I set the water line about an inch below the red ring on the skimmer body. I find it give the bubbles more space to build up. The skimmer is in 8" of water at the moment.
__________________
60" 120G project-DONE!!!! |