Overflow too high

[Doug]

Im running a Eheim 1262. Maybe have to go to a MaxiJet. I don't require a ton of flow from it either but worry how my 2 MP40,s, RW 8,s & Maxspect 150 will make much surface movement

[Aquattro]

Pump should be fine. I have 2 Tunze 6055 and 2 Jebao RW15 and waves splashing out of the tank. Not an issue.

[Bblinks]

Doug, it's hard to tell from your picture but the level its at now looks okay to me. Really need to see it fully running to be able to tell. Worst case you will have to bring out the diamond bit and shave off a quarter inch from the overflow glass.

[Doug]

Originally Posted by Bblinks

Doug, it's hard to tell from your picture but the level its at now looks okay to me. Really need to see it fully running to be able to tell. Worst case you will have to bring out the diamond bit and shave off a quarter inch from the overflow glass.

Is that possible? I was looking for info on it this afternoon.

[Doug]

I know its hard to say without actually running. May rig something up tom. with my Mag 12 and see.

[Bblinks]

Originally Posted by Doug

Is that possible? I was looking for info on it this afternoon.

I have shaved off glass with my die grinders(Dremel) before and if you take your time it should come out nice. It does leave quite a bit of a mess though, most likely have to tape off the tank with cardboard cut to size and masking tape. I also put masking tape on the glass outlining where I need it to stop as a reference and it will prevent the glass from the possiblity of cracking. I am no expert by any means, this is just from my own experience. Contact a local glass shop and as the what is the best but to use.

[Doug]

Ha. Fixed it good. Concepts is cutting me new ones including overflow teeth.

Of course that means draining tank, and cutting it out. Blah

Thanks everyone for all the good advice.

[Aquattro]

probably should have left it alone