#1
|
|||||
|
|||||
Overflow too high
Well thats just freakin lovely. Cut my overflow glass too high. Works but water level to near top. Should have listened to the tank builder at Concepts....but oh no, I know better. DOH!!
Anyone have a solution besides emptying tank & redo overflows walls
__________________
Doug Last edited by Aquattro; 06-28-2015 at 07:47 PM. |
#2
|
||||
|
||||
Stretch the aquarium higher?
__________________
........ |
#3
|
|||||
|
|||||
__________________
Doug |
#4
|
||||
|
||||
I like danger.I run mine 3/8 from the bottom of the euro brace.
|
#6
|
||||
|
||||
This is true
|
#7
|
|||||
|
|||||
Hmmmmmmmm. Thanks guys. I going to go look at that
__________________
Doug |
#8
|
|||||
|
|||||
This is without overflow running, just at top of lip. I could take my eggcrate guard off, giving me another 1/4 in. perhaps. But then no protection
__________________
Doug |
#9
|
|||||
|
|||||
Im half an inch to trim, 1in. to top of trim and tank. Again not running , just at lip.
__________________
Doug |
#10
|
||||
|
||||
Imo you are good to go.
|