|
|
|
|
|
#1
04-20-2005, 08:34 PM
|
|||||
|
|||||
If you got a Mak4 and it was too much flow you could always tee it off before going into the skimmer with one pipe going straight to the skimmer and one pipe going back into the sump and a ball joint on it. That way you could control what percentage of the water from the Mak4 goes into your skimmer.
If it were me I would try a Mak4 and then do this if you have problems. JMO.
__________________
Brennan 
|
Hybrid Mode
