![]() |
|
Portal | PhotoPost Gallery | Register | Blogs | FAQ | Members List | Calendar | Search | Today's Posts | Mark Forums Read |
![]() |
|
Thread Tools | Display Modes |
|
#1
|
|||||
|
|||||
![]() Was just thinking I barely ever use my refractometer anymore ever since weighing salt instead of measuring by the cup. Picked up a digital kitchen scale from Costco a couple years ago and find it way more consistent than measuring by the cup ever was. I mix 10 gallons at a time and add 1440 grams (1.44kg) of basic instant ocean salt. Not sure if other brands require the same weight to water ratio? I get 1.025 every time. This method along with an auto top off =
![]() Just thought I'd share that tidbit of info in case anyone had/has difficulty with consistency using cups. If anyone else does this, what brand/type of salt do you use? How much weight and what's your salinity using this method? |
#2
|
||||
|
||||
![]() been using the 1/2 cup per gallon with I/O on and off for years.
3 cups per brimming 5 gallon bucket and pretty much bang on every time. I don't doubt that using a scale is more accurate but I also never see any ill effects from adding NSW that's not the EXACT same parameters of the tank. |
#3
|
||||
|
||||
![]() Quote:
|
#4
|
||||
|
||||
![]() for sure.
Which about the volume of water in a brimming 5 gallon pail. the "rim" on the outside of a salt bucket is actually where the 5 gallon mark is, fill it up to the top, it's closer to 6. if you put 2.5 cups in a brimming 5 gallon, it gets you around 1.22 ppm. 3 cups get's you 1.24-1.25. Not all buckets are the same, so should say I use IO or Seachem buckets. Quite a few salt companies use the same bucket manufacturer though. Last edited by gobytron; 04-22-2016 at 07:33 PM. |
#5
|
||||
|
||||
![]() did not know that. thank you
|
#6
|
|||||
|
|||||
![]() Keep in mind that salt will be heavier when it has absorbed some humidity out if the air. In other words, don't rely on the weight and do check with a refractometer after mixing.
|
#7
|
|||||
|
|||||
![]() Good point. I only have the lid off for 30 seconds each time and buckets are kept in the closet (lowest humidity in the house) and i always scoop the top layer of salt off if that makes any difference who knows.
|
#8
|
|||||
|
|||||
![]() Quote:
I LOVE THAT! Describes my day to day struggles with this wonderful hobby. We can read and read and read and then read some more, and still be not *quite* sure what we are doing is the right thing for that day's situation. And this is usually after very careful consideration and being sure not to respond in panic mode. I apologize for the off-topic response, but just the way you wrote that made me laugh. ![]() But hey - I guess I can in fact contribute - I use H2Ocean salt, with a level half cup of stirred-up salt taken from my big so-heavy-I-can't-move-it bucket, dumped into one gallon of room temperature RO/DI water in a two-gallon plastic former Milk Bone dog biscuit jar (clear plastic, cylindrical shape). I have three of these, and usually mix one gallon in each. Then I get my big plastic slotted spoon and stir it madly in one direction until there's a whirlpool in the middle, then abruptly stop and go the other direction (takes about 12 fast stirs), repeat, then walk away and let them all clear. Then I pour them into each other several times to aerate and mix the water further. Measures 1.025 every time - I always check before using it. I also check the temperature before doing the water change and if it's more than 5 degrees different than the tank, I put the big jugs on the heated bathroom floor for about an hour - this always does the trick. Well now. I didn't realize I actually had a "regimen." Huh. |
#9
|
|||||
|
|||||
![]() I only do water changes on Wednesdays in months that have an R in them and a waxing gibbous moon! Lol
![]()
__________________
Red Sea REEFER 450 |
#10
|
|||||
|
|||||
![]() Quote:
![]() |
![]() |
Thread Tools | |
Display Modes | |
|
|