Maxspect Gyre FX150 review

[Madreefer]

I have 2 FX150 in my 240G they work far better than the 4 MP40s I once had and better than the 5 Tunzes I had in this same tank.

I ran only one of the Gyres for a month or so while one of them was defective and it worked well.

A client of mine also runs 2 Gyres in a 350G.

I run both of mine at 100% and it is not too powerful and does a great job at getting every spot of the tank. I switch the settings up on them daily and dot run both of them in the same setting at once. Good random flow.

You will not need supplemental flow. As you can see i've tried pretty much all powerheads and I find the Gyres to perform the best. Build quality could be a little better but I have'nt had any issues other than one arriving defective.

[Myka]

Originally Posted by htfn

Some review says running more than 50% might be noisy

Yeah, that's a good reason. I haven't noticed them to be too noisy though - well, not in comparison to VorTechs.

Originally Posted by Madreefer

I run both of mine at 100% and it is not too powerful and does a great job at getting every spot of the tank. I switch the settings up on them daily and dot run both of them in the same setting at once. Good random flow.

I don't know how you do that. My client has two FX150 in his 10 foot tank running at 50% and if I turn them up any higher his LPS will be ripped off their skeletons. His SPS are up high where the gyres have stronger flow. I use a couple Tunze 6105 to help even out the flow through the tank. I imagine it has a lot to do with rock formations too though. I haven't messed around with the settings a whole lot though - they are just ramping up and down (slow pulse).

[Madreefer]

Originally Posted by Myka

I don't know how you do that. My client has two FX150 in his 10 foot tank running at 50% and if I turn them up any higher his LPS will be ripped off their skeletons. His SPS are up high where the gyres have stronger flow. I use a couple Tunze 6105 to help even out the flow through the tank. I imagine it has a lot to do with rock formations too though.

Well if someone tells me how to put a video on here I'd show you. My tank is 30" deep so that may have something to do with it. I have the Gyres facing each other and the tank is 60" long. My LPS are not disturbed one bit.
And with the new mounting brackets the Gyres come with the are virtually silent at 100%

[Myka]

Originally Posted by Madreefer

Well if someone tells me how to put a video on here I'd show you. My tank is 30" deep so that may have something to do with it. I have the Gyres facing each other and the tank is 60" long. My LPS are not disturbed one bit.
And with the new mounting brackets the Gyres come with the are virtually silent at 100%

Yeah, I really haven't noticed much noise from them either - just a ramping up and down like you can hear with Tunzes.

Ah ok, the tank I'm referring to is 120 x 30 x 24" and the Gyres face each other too. I have a 6105 in each back corner blowing across the back pane. When I was setting them up I tried with just one running and the single one could turn the whole tank quite well, but it was too much for most of the LPS.

[htfn]

I actually see Gyre in person today and I didn't notice any noise. Flow was good as almost all review say. I think I'll go for Gyre instead getting two MP40s.