Scott's 135 gallon display tank build

[Gp Scott]

Originally Posted by patman

http://forum.neptunesystems.com/show...ighlight=jebao

That's the program I use but i've changed around some of the time and the intensity.

I signed patman to my apex to see if he could program it see what happens.

[patman]

Originally Posted by Gp Scott

I signed patman to my apex to see if he could program it see what happens.

i got in. Have a few meetings right now. will look later.

[Gp Scott]

Put together this bad ass skimmer and tried out.

[patman]

Looked at the programming. Looks straight forward. Ramps up to 66% and 55% respectively over the day and then back down. Right now it's at 64% and 40%. Not sure what you think it isn't doing. if you try making a change sometimes it takes a few minutes before fusion communicates with the base unit. Maybe let me know what you think it should be doing and what it is doing.

[Gp Scott]

Originally Posted by patman

Looked at the programming. Looks straight forward. Ramps up to 66% and 55% respectively over the day and then back down. Right now it's at 64% and 40%. Not sure what you think it isn't doing. if you try making a change sometimes it takes a few minutes before fusion communicates with the base unit. Maybe let me know what you think it should be doing and what it is doing.

Sometimes they just shut right off I have to try and set the times on it and also add a heater not sure how to Change plug names

[patman]

Hmmm. Does it only happen when the speed is down? I read somewhere where it sometimes doesn't like it when it gets below 20%, but then I just read today where Torx posted it sometimes doesn't like it when it is below 40% or 2v.

You can't change the outlet name in Fusion. You have to use the regular Apex program, go to Configuration and outlet setup.

[Gp Scott]

Originally Posted by patman

Hmmm. Does it only happen when the speed is down? I read somewhere where it sometimes doesn't like it when it gets below 20%, but then I just read today where Torx posted it sometimes doesn't like it when it is below 40% or 2v.

You can't change the outlet name in Fusion. You have to use the regular Apex program, go to Configuration and outlet setup.

Not really sure I have been trying to set each wave maker separately and change what it does but so far one pump switch on dash board runs both