|
|
|
||||||||
| Portal | PhotoPost Gallery | Register | Blogs | FAQ | Members List | Calendar | Search | Today's Posts | Mark Forums Read |
|
|
Thread Tools | Display Modes |
|
#3
10-12-2011, 08:38 PM
|
|||||
|
|||||
Can you post a couple pic's of it and the parts, if they are not attached or being used. I use to have a RS180. RC means recirculating, so if you have a second pump attached to it, then it is a RC, otherwise RS.
Should be simple, its a matter of adjusting the air flow and water flow. What most are missing are air adjustment valve. If you don't have one, then you can probably get one from Kevin @ Red Coral or JL online. If the skimmer has been running for a bit, great... It will be a matter of getting the bubbles as fine as possible, using the air adjustment. Then adjusting the water level. I use to run my water lever to the base of the skimmate cup. I hope this helps.
__________________
 Setup: 180G DT, 105G Refuge (approx. 300lbs LR, 150lbs Aragonite) Hardware: Super Reef Octopus SSS-3000, Tunze ATO, Mag 18 return, 2x MP40W, 2X Koralia 4's Wavemaker Lighting: 5ft Hamilton Belize Sun (2x250W MH, 2X80W T5HO) Type of Aquarium: mixed reef (SPS & LPS) with fish Dosing: Mg, Ca, Alk 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode
