Well ive been bored lately and decided to start a project. Actinic LED supplementation. Never having soldered or done anything remotely electrical i decided to start with some cheap 3w blue leds instead of frying cree's. for drivers I am waiting for some meanwell eln-35-700 drivers. I ordered 20 leds's and picked up some u-channel to use as the heat sink. Since these are cheap led's i am not going to go all out and make everything look pretty.
Havent put it over the tank yet as i am still waiting on the drivers
Here is my attempt at something DIY. the bar is going to be about 16" because i am not sure if i will use it on the main tank. and if i is that length i can always put it over the biocube.
03-19-2011, 02:10 AM
Threaded Mode
