|
|
|
|
|
#1
01-31-2011, 08:42 PM
|
||||
|
||||
Okay I have a better skimmer that I may be able to get working in the tank. I have to drain my tank so I can out it on the new stand that the sump is in, so I don't think I can get the sump up and running quite yet, but I will put the new skimmer on it.
|
|
#2
01-31-2011, 09:13 PM
|
|||||
|
|||||
|
what size of tank is it?
Quote:
|
|
#3
02-01-2011, 12:32 AM
|
||||
|
||||
|
Quote:
|
|
#4
02-01-2011, 03:18 AM
|
|||||
|
|||||
|
Ok that explain why 50ml was still enough to create a bacteria bloom. You should start with something like 10ml and build your way up. I think 50ml was too much to quick.
Quote:
|
|
#5
02-01-2011, 03:48 AM
|
||||
|
||||
|
Yeah I think your right. When I start them up again in a few weeks I will only start with a table spoon at most.
|
|
#6
02-01-2011, 04:00 AM
|
|||||
|
|||||
|
Don't worry about running any pellets until you get the whole sump/skimmer issue dealt with. In order for the pellets to be successfully run in a tank you have to have a skimmer that is capable of removing the bacteria that the pellets produce. Also your pellet reactor output should be directed directly at your skimmer input for maximum benefit.
__________________
|
|
#7
02-01-2011, 06:10 AM
|
||||
|
||||
|
Okay, good to know. So when I do get my sump and new skimmer up and running, I should put the bio-pellet input/output right where the skimmer is?
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
