|
|
|
|
|
#1
12-30-2010, 04:09 AM
|
||||
|
||||
How about 2 pcs of 3/4" steel tubing cut to fit the inside length of the tank? Or you could use a couple of 1x4 or 1x2 pieces of lumber as the actual height is 3/4". You could cut out a piece of plywood to fit inside the bottom of your stand but I would still support it underneath with the 1x2's as even small sags can cause a tank to crack.
|
|
#2
12-30-2010, 05:14 AM
|
|||||
|
|||||
|
sump is a 33<36x12.5>
tank 50g and stand <36x18> I have had the 33 in a few shabby setups in the past but nothing that just holds on the short edges. wood support is probably easier for me than metal. Last edited by blacknife; 12-30-2010 at 05:16 AM.
|
|
#3
12-30-2010, 06:41 AM
|
||||
|
||||
|
you got that right unless your grizz and got a master welder cert. lol um id just say build a new stand that holds both properly im out in the garage tommorow building cabnets if you need guidance you have my number
Last edited by Edmonton newbie; 12-30-2010 at 06:46 AM.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
