![]() |
|
Portal | PhotoPost Gallery | Register | Blogs | FAQ | Members List | Calendar | Search | Today's Posts | Mark Forums Read |
![]() |
|
Thread Tools | Display Modes |
|
#1
|
|||||
|
|||||
![]() You didn't start anything Jenn, it happens around here often all by itself. It seems people get their panties in a twist if you don't say "In my opinion" or "In my experiences" at the beginning of every paragraph.
![]() Try talking to Kevin at Red Coral for drilling your tank. I'm not sure what he charges, but in my experiences (lol) $20-30 per hole is fairly typical. If you do decide to drill the tank, put some time into planning and deciding what type of drain you want even if you don't install it right now. Kevin should be able to help you with that too. Last edited by Myka; 04-28-2010 at 07:35 PM. |
#2
|
||||
|
||||
![]() Quote:
when adding 3 words can make such a big difference... an as for bunched panties, these were on the soapbox when I got here ![]() You might consider a siphon overflow until you move. even the people who strongly advocate against them might agree that as a temporary solution until you move and can have your tank drilled while you are moving (or even buy a new system that is pre drilled and sell your old one). Ask around and I think you will find that most people who hate on the siphon overflow haven't actually used one or didnt have it set up properly... Here's a link to a very high quality one that you can look at if you want to consider an alternative to drilling right now, keeping in mind you can often pick these up for under 50$. http://lifereef.com/frame.html If not, you might want to post your question about where to get drilled in the Alberta forum so that you get the question to an audience who could best answer you from experience... Last edited by gobytron; 04-28-2010 at 08:00 PM. |
#3
|
||||
|
||||
![]() Quote:
Bill |
#4
|
||||
|
||||
![]() Just a somewhat side note...
If you have your overflow and flow set up properly, you will NEVER see microbubbles in your tubing. The only reason that this happens is not enough flow to create enough force to have the bubbles organically pulled out of the tube... I think that this is th emost common error in setting these up and also the main reason for failure. |
#5
|
||||
|
||||
![]() Quote:
Bill |
#6
|
|||||
|
|||||
![]() Quote:
![]() Quote:
![]() ![]() |
#7
|
|||||
|
|||||
![]() ![]() |
#8
|
|||||
|
|||||
![]() I see nothing wrong with what Myka is saying at all. She's actually speaking from experience. Fishgirl asked for opinions and she got it. No need to attack someone because you don't agree.
|
#9
|
||||
|
||||
![]() Quote:
If I were a lonely tradesman in saskatchewan I would be looking for laughs anywhere I could get them too... ![]() And FYI, even at 60-75% of a discount, which is rare as in my experience, unless the equipment you are buying is in really poor condition you can really onlyexpect a 30-40% reduction from retail price. and even then, it's always a challenge to find exactly what you need when you need it. But lets assume you do get that wonderful discount on used....lol It`s still expensive to a lot of people...not everyone is a ticketed journyman without much more in life than their aquarium to spend money on... ![]() Myka voiced one strong opinion and I voiced another... I certainly didn't consider anything in this discussion a "fight" or an "attack" (like when someone picks apart your choice of words to describe something you consider helpful and pertinent to the thread when their only intent is to try and embarass you...lol) as it was already mentioned some here do. Can there be only one voice on this forum...lol I regret that I don`t have a thousand or more posts, but I still feel that I should be able to express myself, even if I don`t concurr with the opinion of someone who`s more....established than me. I had thought that we were done here and that this thread could be given back to the original poster but then I find that the soapbox has once more been set up...lol |
#10
|
|||||
|
|||||
![]() Quote:
![]() Quote:
Quote:
Last edited by Myka; 04-29-2010 at 04:39 PM. |
![]() |
Thread Tools | |
Display Modes | |
|
|