Today I decided to top up my NP BioPellets and while I was at it, I figured I'd re-plumb the reactor. The reactor, although performs beautifully, is kind of awkward to plumb. Currently I have a crap load of hose adapters to go from my MaxiJet 1200 into the Vertex with hose snaking through the sump. Not a very clean setup but got the job done.
Instead of flex hose all over the place I decided to use rigid 1/2" PVC and cemented all the pieces together. I also wanted to minimize the footprint of the whole rig so it took a little playing around with. I also wanted to increase the input so I threw a bigger pump at it.
Utilizing this cheap-o 500gph pump from Odyssea.
Here's what I ended up with..
here she is in the sump.
Even with all of those 90 degree bends I still have to throttle back (about 1/4 turn) the input or the pellets get blasted through the outlet. Also, as you can see here the outlet drops right in front of the inlet to the skimmer.
and here is my new full sump shot.
04-23-2010, 09:16 PM
Threaded Mode
