Need Idea's for CNC mill

[pterfloth]

That's fine. I'm supposed to be working too.

[banditpowdercoat]

Ohh, Im buying a lathe too Maybe next week????

[pterfloth]

So put me first in line for a Bandit Skimmer!

[sphelps]

Originally Posted by banditpowdercoat

Ohh, Im buying a lathe too Maybe next week????

Nice, CNC??

[banditpowdercoat]

Originally Posted by sphelps

Nice, CNC??

Not at first, But I built my CNC for my mill, so I'll build the lathe into a CNC

[banditpowdercoat]

Pin wheel's and Venturi's/New Volutes for MAG pumps, would that be of interest? The Lagunas are a great possibility, but I see a few allready make conversion kits. I don't want to be a copy cat. MAG pumps I run myself, cheap, but the impellers never last neither. Might not be a market there?

I have to admit, Im new to the whole pumps sucking air, needle wheels, Mesh wheels etc. And I dont have the funds to go out and buy a bunch and test. Reading RC makes me mad and gives me a headache. there's allways fighting and nonsence on there. Seems like on a 50 page thread, there's only like 7-8 pages of USEFULL info, but takes 3 days to read and process it all

[pterfloth]

Yes. The RC threads can be a drag. Too many people trying to impress each other. When all is said and done, there is a lot more said than done.

Haven't used Mag pumps myself. Just interested in a quiet, reliable, reasonably priced skimmer pump. At $339, the Askoll looks good, but that's close to the cost of a skimmer.

[banditpowdercoat]

Which pump was $339 and where? Ya that IS alot for a pump, but is that the same(apparently) as the one RD sells for $1k? I dont even have a skimmer that would need a pump that big yet LOL