kien's 150g Room Divider Mixed Reef & Stuff

[kien]

Originally Posted by mseepman

...Are you happy with the build quality?

.. was that acrylic doesn't stick to silicon/glass and some of my baffles started falling over. I haven't fixed it yet, but you might want to research what others have done to combat this.

I am very happy with the build quality. I have inspected every inch of it and it just looks fabulous all around. Polished edges are nice and smooth, silicone is nice and clean, walls are nice and straight :-)

I was somewhat paranoid about this too so I may have over engineered the baffles.. ie, I put gobs and gobs of silicone on.. hehe! That's why it looks like the baffles were installed by a monkey. Did I mention that there were gobs?

Originally Posted by Delphinus

Kien's just being modest. He actually carried the tank strapped to his back on his crotch rocket motorbike. I offered to help him carry it home but he was insistent he do it himself. At work on Friday he was using the tank as his coffee mug!

LOL! nice :-)

Originally Posted by Eb0la11

Looking good Kien. Definitely like Colby's work on tanks. I might go with him for my next tank, but I have a feeling that wont be for 4-5 years haha.

One thing your build shows is that I need to learn how to use my camera cause my shots look like garbage compared to yours.

Thanks! Ya, as I said already, I'm very very pleased with his work. It was worth every penny and let me tell you, there were quite a few pennies involved!

I'm looking forward to plumbing this bad boy up during the course of this week. Targeting Sunday to start water testing it.

[kien]

Originally Posted by banditpowdercoat

HUH??!! Did He say CAR? What you drive, a Hearse?? LOL. I need to see pics of that!!

Well, okay, it was a large car! Nissan Murano, with both the rear seats down and both the front seats pushed as far forward as they could possibly go! It was fun driving the tank home with my steering wheel in my gut.

[Eb0la11]

Where are you going to be looking for most of your plumbing parts. I went to home depot and the selection was lacking a bit. Lots of copper parts and typical piping parts like 90 degree bends and 45s but some of the other parts are missing. I couldnt find any gate valves that were pvc and no ball and socket spray parts along with other ones I need for my setup.

[xtreme]

Rona has a better selection of PVC than HD. You should be able to find most of what you need there. The only thing they won't have are gate valves if you are planning a herbie.

[kien]

I picked up some gate valves and some misc attachments from Red Coral last weekend. I picked up a nice green ball valve from Rona on the weekend as well (I have this thing for green stuff). Colby is providing me with the bulkheads for all my holes. He also suggested that I check out Western Pump. They are literally 5 minutes from my house (on 114st near Barlow Trail SE), so I'm going to stop in on my way home from work one of these evenings and check them out. Although, as xtreme said, Rona has the largest selection I have seen so far, minus the gate valves and bulkheads.