Contest #1 Nano - New Rock Work

[sphelps]

Yeah I figured you might have to with the overflow, the water level had to be as low as possible to reduce the first sump chamber, which is still a little too high.

Is the sump level? If the sump is level the water flows against the baffle but if the right side is sagging the water will separate. The eggcrate will work if you want to run a higher water level. You could also hang filter floss on that baffle, the water will have to go down through the floss to get into the second chamber. Don't run the sump too high that you can't turn the pump off.

It would have been better if that second last baffle was taller but that's what you get for working with scraps

[superduperwesman]

No big deal... I'll just add some egg crate where I showed it in the diagram

ahah good thing you reminded me about the water level... I almost forgot that it needs to be down enough so the sump wont overflow... I marked where the level should be maximum tonight

You doing anything for water top off? Or just doing it manually? I forget do you have lid?

[sphelps]

I'm topping off manually to keep things simple, I might have to rig something up later down the road when I'm gone for over a week. I did make a lid but it's not all glass, it's a glass frame with mesh in the center. This way it cuts back a little on evaporation, keeps livestock from escaping and still allows heat exchange so the tank doesn't over heat from the lights.

[superduperwesman]

So how much you topping off per day??

[sphelps]

Originally Posted by superduperwesman

So how much you topping off per day??

about 2 cups a day, but I usually just put in a liter or two a week.

[superduperwesman]

So tonight I'll be trying to get the fuge light mounted to the lid of the right compartment.

and adding egg crate... and I still need to find something to put under the one side of the stand to level things off... I was going to use the pink foam but its $20 a piece

[Ryan_Lap]

Originally Posted by superduperwesman

and I still need to find something to put under the one side of the stand to level things off... I was going to use the pink foam but its $20 a piece

Use cardboard...its free. You shouldnt be able to see it either.

[sphelps]

I think you should get 4 screw-in stump legs, similar to what you would find under a common couch and similar to left leg shown below. But a lower profile so you won't see them.



This could also allow for adjustment, a couple washers should do the trick. It might be easier using foam or cardboard but I don't it will work as well, using legs will also make it more stable.