New Tank with 3D Sketches with Stress Analysis - Canreef Aquatics Bulletin Board

		Canreef Aquatics Bulletin Board > General > DIY
New Tank with 3D Sketches with Stress Analysis

05-22-2008, 03:31 PM

sphelps

Member

Join Date: May 2006

Location: Lyalta, East of Calgary

Posts: 4,777

Something like this for the back?

You'll want round corners on the brace, otherwise you'll get stress concentrations and it will crack.

I'll draw something up for a wall mount when I get a and with a little FEA we should be able to figure something out.

Good to see you again Wes!

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT. The time now is 09:50 PM.