Zeovit reactors - *testing done*

[Myka]

Where are you finding the acrylic? Are you getting a discount or paying full retail? I wonder if I could help find some cheaper...

Would a 1.5-2.5 L media capacity reactor be $178 as well, or would it be a bit cheaper? What were you thinking of adding on top for your time?

[kari]

Originally Posted by Myka

Where are you finding the acrylic? Are you getting a discount or paying full retail? I wonder if I could help find some cheaper...

Would a 1.5-2.5 L media capacity reactor be $178 as well, or would it be a bit cheaper? What were you thinking of adding on top for your time?

I am purchasing it at $44.37/ft ( 6"OD 1/4"wall cast ), $30.58/ft (6"OD 1/8"wall cast - none available), $29.22/ft (5-1/4"OD 1/8"wall cast.) The prices will very by the week.

For a smaller reactor I would just shorten the tubes and price would change equal to cost of the tube. Labour time would not change and could do it for $80.

The horizontal design is much less in materials since it is much shorter and no inner tube while acheiving the same volume. Should make one and find a guinea pig.

[andresont]

can you please elaborate on how small horizontal unit will shake the media with 25 degree rod rotation?
How will this be done?
thx

[kari]

Originally Posted by andresont

can you please elaborate on how small horizontal unit will shake the media with 25 degree rod rotation?
How will this be done?
thx

The 25deg number was something I quickly winged but will probably be a larger angle. Using the 6" pipe I figure the media section length will be 13" long for 5 liter, 11" for 4 liter, 8" for 3 liter, 5.5" for 2 liter.

The head scratching part that remains is the water in and out connection. John guest type fittings may not work and I will have to find something else that can be just as easily disconnected.

I'll put one together right away and see how it works.

[steve fedyk]

If the price is right I'll take a 2.5L reactor.

[Der_Iron_Chef]

It sounds really interesting. I'm intrigued!

[Richard_Dicosimo]

i have been looking into building a skimmer lately and have priced out some 6" acrylic tubing all 1/8" and if you buy a 6' length from industrial paints and plasitcs in Calgary they will sell it to you for 105$ nearly halfs your main chamber costs.
they are located in the industrial park in the s.e. near chinook center, they also had the 6" in stock when i was there last wednesday. also i found a site on the internet www.k-mac-plastics.com they aslo sell the acrylic tube for less then you say you can get it IF you buy in a 6' lengths. hope this helps you some.

Richard