notching tank for external overflow - Canreef Aquatics Bulletin Board

		Canreef Aquatics Bulletin Board > General > DIY
notching tank for external overflow

Thread Tools

Display Modes

12-22-2007, 01:35 AM

mark

Member

Join Date: Nov 2002

Location: Edmonton AB

Posts: 4,212

Used the diamond encrusted bits (just picked up another pack (30 bits) today fr PA for 4.99). Didn't get it but was also looking at a diamond wheel about 1.25" dia, not sure if it's just for cutoffs, grinding or if could be used for grooves.

The spreadsheet is neat that you can put in 1 opening.

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT. The time now is 11:26 PM.