Aquaclear powerheads

[cav~firez22]

I have an aquaclear 30 & 70, Both are completey submerged. The AC30 is in the rocks somewhere.. so Yes you can submerge it. the electrical components are sealed with epoxy. An answer to your question.

[MikeP]

Thank you, I just wasn't 100% sure and like I said above, the instructions sucked.

[albert_dao]

You're not suppose to because it doesn't meet CSA standards to be submerged. Everyone does though, because, quite frankly, the entire motor casing is a solid block of water-tight epoxy.

Personally, I find that traditional flow powerheads are a waste of money unless you're trying to do a non-flow related app. (eg. kalk mixer).

[Beverly]

Originally Posted by albert_dao

Personally, I find that traditional flow powerheads are a waste of money unless you're trying to do a non-flow related app. (eg. kalk mixer).

I've used Hagen powerheads in all my tanks since beginning reefing back in the late '90s and have found them to be very versatile. The amount of flow can be regulated on them, the direction of stream can be changed ~270 degrees all by moving the nozzle from one side to the other, they can be placed high or low in the tank (though I prefer them high), they can be removed easily and cleaned frequently, they are relatively inexpensive, they can easily be anemone-proofed. Gads! They're pretty darned good in my books

[albert_dao]

Originally Posted by Beverly

I've used Hagen powerheads in all my tanks since beginning reefing back in the late '90s and have found them to be very versatile. The amount of flow can be regulated on them, the direction of stream can be changed ~270 degrees all by moving the nozzle from one side to the other, they can be placed high or low in the tank (though I prefer them high), they can be removed easily and cleaned frequently, they are relatively inexpensive, they can easily be anemone-proofed. Gads! They're pretty darned good in my books

Replace one with a SEIO (economy) or a Tunze (high end) and tell me you'd go back...

[Beverly]

Originally Posted by albert_dao

Replace one with a SEIO (economy) or a Tunze (high end) and tell me you'd go back...

I've seen SEIOs in tank pics. Those things look like monsters Not that the Hagen PHs are anything to write home about in terms of size. However, I'm most concerned now about keeping my two BTAs safe in the event they decide to wander. I've read nothing but troubles and difficulties making SEIOs and Tunzes anemone-safe.

[Murminator]

~*~*~*~ Warning Rant~*~*~*~*~

WELL.... where do I begin I have 2 AC powerheads the 1st problem with them is when the power goes out or flickers the frickin this will not start back up they just humm and do dick all then you have to bang then turn them up side down shake yell at them ....to get them started again WELL GUESS WHAT????.... that was a nice storm last night power went out and flickered a bunch of times had to kickstart the powerheads a couple times. well the power musta flickered after we went to bed and woke up to a dead tank this morning all my sps except a cap, yellow tang, clownfish, 6 line, and 2 chromis gone. the water was like glass not a ripple nothin working got the big powerhead running by shaking it and pluging in and out half dozen times the other got smashed into bits against the basement floor I will never own another one I will be putting in an order for some new seio's....lets put it this way I REALLY have to choose my words right now so I don't get banned