|
|
|
||||||||
| Portal | PhotoPost Gallery | Register | Blogs | FAQ | Members List | Calendar | Search | Today's Posts | Mark Forums Read |
 |
|
|
Thread Tools | Display Modes |
|
|
|
#1
03-28-2006, 04:55 PM
|
||||
|
||||
7 days!!!!
My euroreef is unstoppable when I use epoxy. 7 days plus to slow it down. If the riser pipe is even installed at lowest level it still spills over the cup. I have found a fresh bag of carbon in high flow area of sump will resolve the problem but so far 7 days the last few times!!!!! Does anyone use super glue Gel underwater wth success??
|
|
#2
03-28-2006, 05:18 PM
|
|||||
|
|||||
|
Superglue works.. it's just a PITA, and it's messy. Usually, you take the frag and rock out, place a generous dab on the rock, place the frag. Hold in place for a few seconds, then place it back under water (still applying pressure) It will bond then.
It's messy though.. at least IME, and quite the pain!
__________________
20g BB Mixed Reef // Coralife 150w HQI // AquaC Nano // Koralia 1 & Seio 820 // Jager 200w // AC50
|
|
#3
03-28-2006, 05:27 PM
|
|||||
|
|||||
|
Quote:
I think that is part of, if not his main, question. (IMHO). Cheers  ,
__________________
Mark. Last edited by Johnny Reefer; 03-28-2006 at 05:27 PM. Reason: Typo
|
|
#4
03-28-2006, 05:27 PM
|
||||
|
||||
|
I usually let the glue dry for a few minutes before adding the frag back into the tank. If you've ever seen pics of reefs in the tropics at low tide, being out of the water for a few minutes will not hurt most corals, especially if they're happy & growing well enough to frag. I've done this with digitatas, zoos especially.
Anthony
|
|
#5
03-28-2006, 05:29 PM
|
|||||
|
|||||
|
Oops, my bad. To answer the question, no. I have not had my skimmer go nuts from using Superglue.
__________________
20g BB Mixed Reef // Coralife 150w HQI // AquaC Nano // Koralia 1 & Seio 820 // Jager 200w // AC50
|
|
#6
03-28-2006, 07:42 PM
|
||||
|
||||
|
cant remove my rock easily, So my question is I heard you can apply lots to the frag dip in water this film of water will harden the glue , wait a minute and put in tank and glue to any rockwork, Basically does anyone have sucess glueing without taking the rock out of the water? thanks
|
|
#7
03-28-2006, 08:02 PM
|
|||||
|
|||||
|
I dunno about that one. I think you would have to be very fast.... fast in terms of , place the glue, and place the frag in spot very fast, otherwise the glue will harden and it wont work.
Actually, I have tried this, and no.. it doesn't really work. Unless your speed racer, the glue just goes all funky when it hits water.
__________________
20g BB Mixed Reef // Coralife 150w HQI // AquaC Nano // Koralia 1 & Seio 820 // Jager 200w // AC50
|
|
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
