Quote:
Originally Posted by patman
Hmmm. Does it only happen when the speed is down? I read somewhere where it sometimes doesn't like it when it gets below 20%, but then I just read today where Torx posted it sometimes doesn't like it when it is below 40% or 2v.
You can't change the outlet name in Fusion. You have to use the regular Apex program, go to Configuration and outlet setup.
|
Not really sure I have been trying to set each wave maker separately and change what it does but so far one pump switch on dash board runs both
09-11-2014, 11:51 PM
Threaded Mode
