01-10-2014, 02:51 AM
|
 |
Member
|
|
|
Join Date: Mar 2009
Location: Stony Plain, Alberta
Posts: 1,641
|
|
Quote:
Originally Posted by Scythanith
Here is what I have tried:
Open ProfilucControl 6.0.4
Connect RS232
Click illumination on the right menu and open drop down menu
Click light composer
It asks me to load own project, which I do. Click OK.
Now I see all the light sources of the Mitras, and my illumination runs. I can click on new under the illumination runs. Other than that the only thing I can select on the front page is test illumination run. If I check it and try to run it nothing happens on my Mitras. It says illumination channels must have been transmitted before, but I don't know how to do that.
I have used this light project through GHL Control Center before I installed the PWC card, so I know it works.
I seem stuck at the transmit to Mitras part. The PWC card has a solid green light and a blinking red light if that matters.
|
Yeah the light means its geting interference, I don't remember if you stated are all your lights set as slaves ?
__________________
360 gallon sps reef, 180 gal sump, bubble king supermarine 300, 4xmp40Wes, 2 x 6215 tunze waveboxes, 4 ghl mitras
360 Reef Tank
|
Threaded Mode
