MH bulb comparison pics

[StirCrazy]

Originally Posted by UnderWorldAquatics

a timer, or any other device put inline between the power source and ballast will act as a resistor and lower the amount of power going to your bulb, so yes it could make the bulb burn irregular... the larger the gauge of wire, and better quality the connections are of any device put inline between your equipment and power source, the less power will be loss due to resistance...
ever pluged a power tool into an extention cord that was really long, sometimes the tool wont work properly, and may even throw the breaker
power works best with the least amount of resistance, thats whay some ballasts say the max length the power cord to the socket can be, because even the cord has resistance...

Ok enuf of this bunk. hell we better take our breakers out and directly wire them to the utility source..

I can't believe you actiualy posted this Kyle..... any timer that is rated for the amprage required for the bulb will not restrict the power to the bulb (unless it is in its off cycle ) you know I even went and measured my draw through the timer last night because even though I knew the timer excuse was junk I thought I might give you the benifit of the doubt.

If you think about it even if it was a little bit of a resistive load it would only increase the total amount of power you consume. a 15 amp timer is not going to restrict a 5 amp load they are simpacly a switch, like a light switch, which when made has a 0 ohm load (I tested 4 different types of timers for this last night including the old 5.00 dial ones) so anyone who is blaming the color of a bulb on the timer better find a new excuse.

Steve