How to automatic mixing water

[sphelps]

Originally Posted by donlite

What I have set at this point is very simple. I have 2- 30 Gallon drums (coke sells used drums for about $20). One is filled with fresh water and is connected to a float switch in my sump. The other tank has saltwater in it. I use one water lifting pump for the top off and 2 pumps for the water change. The water change pumps turn on and off together throughout the day. The problem is that the 2 pumps must have the same flow rate. I checked them and they are almost the same. I also have a second float switch that turns all the pumps off if something stays on or off. It is not a perfect system but it seems to work.

Yeap a very common method and works well for many people. With almost any system you'll still need to check salinity and make adjustments. Even systems with conductivity probes I still found the calibration/set points required slight adjustment every few weeks.

Rather than matching two pumps I find the use of float switches to remove and replace a consistent amount of water takes a lot of the guess work out.