|
|
|
#21
12-03-2003, 10:50 PM
|
|||||
|
|||||
I doubt that this was caused from the tempature of the bulb as they are only slightly over 130 degrees. usaly this is cause from the caps being installed incorectly and every time they are started there is a slight arching. eventualy this will get stronger untill this happens. this is why I use the push on water proof ends at they clip on much tighter and give a more solid conection and are also totaly water proof not just semi water proof.
If you want that type of end again Brad I know whare you can get metal industreal ones but they are a little more expensive. Steve
__________________
 *everything said above is just my opinion, and may or may not reflect the views of this BBS, its Operators, and its Members. If cornered on any “opinion” I post I will totally deny having ever said this in a Court of Law…Unless I am the right one*Some strive to be perfect.... I just strive. 
|
Threaded Mode
