48" LED Array - Up and Running...Mostly

[StirCrazy]

Originally Posted by Canadian

IFWIW, I agree. This was only commented on because Steve got involved in the conversation and has, in the past, made a big deal about the high PAR values he got with his DIY MH setups on his SPS tanks when comparisons to T5s were made. Now that LED PAR values in a typical setup (such as yours) seem to be similar to those of "good" quality T5 setups (see pictures above) he seems to be suggesting those PAR values are now acceptable.

Oh Andrew, I never said they are aceptible or not aceptable, if you go back and look at 99% of my posts on the T5/MH issues it was when people were claiming T5's were more powerfull then MH, and you were one. and if you read carfullyI said many a time that you could grow SPS under a NO bulb as it was done before buy a guy on this board.

your Hi quality T5 set up you showed there, is there any distance referances? and whats the point of taking readings int he air 1/2 way between the reflector and the water? so just under the surface it looks like he has a 575 average in the well lit area. at the bottom about 280ish. the hot spot is a little higher than the numbers but the other areas are lower. (I never realized the hot spot on T5s would be that pronounced) at any rate His number were very comparable with your high end T5 with new bulbs. although we would need measurments of all the reading positions to be sure. so what happens if he adds more LEDs.. nothing, bt if he adds more LEDs to reduce his spacing then adds 40 degree optics his numbers should jump by about 50% from what I have been seeing. if he adds more and then goes 20% optics.. problem is the spacing is so tight on 20% or lower optics it would only be a reasonable cost on a 20 gal tank or less, but man would you pack some punch. I know there are some people trying the the newer bulbs that have about 3 times the output as the ones Ron is using but they don't make that strength in a Royal blue yet so it is only good for the white and they are finding it is to powerfull for any other lighting they try to give it a blue look as it just washes it out. now if you like the icewhite look to your tank, which I tend to.... they might be a awsome bulb to try. I am actualy going to buy a handfull of LEDs and build a tiny cylinder that is about 24" tall but small enough aroundI can lighting it with 2 or 3 LEDs so I can try some different combos on my Ardunio and see what kind of color blending, lenses and PAR values I can get a different depths. just have to clean my shop out first.. which at the way I am goiong should be another 6 months

Steve