|
|
|
#3
01-19-2010, 12:33 AM
|
|||||
|
|||||
You can save the 'wave' in both Short & Long Pulse mode by holding the Set button until the LED flashes green/white when you're done dialing it in. I can't honestly say that it will retain that setting if you switch to another mode, I'll have to try it. I run my two in Long Pulse mode (Master/Slave, anti-synch) and have saved the setting. I do know that the setting is retained if I unplug the Master. The Slave also remembers that it is in Anti-Synch after I power it down and back up again. The master shows the correct 'Salmon' colour LED when ramped up and a Green LED when at idle. I'm fairly certain the Green means the setting is saved.
I have the long pulses at about 10 seconds up to 80% power. It does not make a surface wave at that setting, but the flow in the tank alternates nicely with the two anti-synchronized.
__________________
Mike 77g sumpless SW DIY 10 watt multi-chip LED build  http://www.canreef.com/vbulletin/showthread.php?t=82206
Last edited by mike31154; 01-19-2010 at 12:42 AM. 
|
Threaded Mode
