Propagation tanks

[StirCrazy]

Originally Posted by jgoldsney

the load is resting is almost directly on a large beam which rests directly on top of a 2X6 load bearing wall. As well there were a few extra TGI floor joists so I had the framer throw them in so where my tank is sitting the joists are about 10" on center.

Joel

I think everyone should read this again (I missed it as well) and get off the subject if "TGI" is a ridgid as traditional joists or not. his set up is a overkill of strenght and a perfect location for a tank.. there will be no bounce. it is resting directly on a enginered "BEEM" on the loadbearing wall. he had "EXTRA" TGI's throwen in.

Steve