|
|
|
#7
05-09-2009, 04:40 PM
|
|||||
|
|||||
One can convert a knife valve to a gate valve if one was willing to DIY - just have to replace the stainless rod with stainless ready rod, do a little tapping & install a thumbscrew... It's extremely cost effective in comparison to buying a true gate valve...
Last time I did it, might have been due to the older tap - it did have an extremely slow drip at the threads coming out of the valve; but the previous 3 conversions didn't...
__________________
By reading, replying to, commenting about, or in any way accessing the material in this post; including but not limited to storing in a database, retrieving from a database, viewing in a web browser, including it in or making a reference to it in a legal document, or accidentally glancing at it you agree to send me $100. 
|
Threaded Mode
