|
|
|
#1
02-05-2007, 10:53 PM
|
|||||
|
|||||
setting up a CAL reactor
ok i have ran a CAl reactor for a bit. Now I have heard to get it going some people apply the bubble count to around 70-80 bubbles and leave it and adjust the Fluid.
Now Doing slowing the enfluent down will give you a high alk and a low CAL right i have the enfluent set to have 6.5-6.7 coming out and gettign around 25 ml per min. what Should I have going at. should I raise the fluid coming out faster to say around 40 ml per min. I would like to have a higher CAl reading and a lower alk. mike
__________________
180 starfire front, LPS, millipora Doesn't matter how much you have been reading until you take the plunge. You don't know as much as you think. 
|
Threaded Mode
