Whoa holy cloudy water batman

[Pan]

Originally Posted by TheReefGeek

I think you should drain all your water, take everything out, rinse out your sand thoroughly, fill back up with RO water and new salt (not the salt you have been using) and put everything back in. Then watch your levels, tank might cycle again, then when it is all good put your clowns back in, and start again slowly with adding livestock.

I used salt that neal gave me for mixing the new water so, it's not the salt.,..it had to be in the substrate....or in the cannister filter...but i cleaned it...
needles to say i am very confused

I don't have any ro water...i might have salt enough to do it..maybe...
think it will harm it until thursday or so...i have no time until then...have to be at work in half an hour...hmm...

if i can find a place to get 20 gallons or so of ro/distilled in the city i will look into it...i think i'm going to go with seachem salt next time here....i'm just worried i am doing this all for naught...and might be better off just using the liverock(if it's that anymore) in a new tank as Base rock...after it's cleaned...being on a student budget makes things difficult to try and hope things work out as opposed to knowing they will...if that makes sense. And since i am getting a new tank anyways....

the most expensive base rock i'll every buy i suppose
whats wierd is all the tests except alk test fine...even ph is about 8.3 but the alk tests so blue it's neon almost....light blue green is normal on my test kit...oh yeah will the liverock hurt anymore than it has just sitting there while i clean the substrate etc? Maybe give the tank a cleaning as well as the filter...can you clean them with bleach? making sure you rinse really well?