Cost Poll

[titus]

Hello Darren,

I have the following:
-----------------------------------------
Flange set (ring and top piece) for 6"OD tube
Flange (ring only, no top piece) for 4"OD tube

The flanges are made from clear 1/4" cast acrylic sheet (paper masking both sides). Keyhole slots, black nylon screws, and matching gasket all included with the flange set. Holes are not tapped. I don't sell amateur flanges. These ones are just as good as the ones you find in Precision Marine products, except it's clear instead of black.
-----------------------------------------
Circular base plate for 4"OD tube
Some smaller diameter circular plates
-----------------------------------------
Cast 4"OD tube 1/8" wall (about 2 ft left)
Extruded 6"OD tube 1/8" wall (40 inches left)

I can get tubings (4" or 6") cast or extruded. Just let me know how long, when you need it.
-----------------------------------------
3 regulators (German)
1 - 2 needle valves

I can order solenoids as well (German)
-----------------------------------------
A whole whack load of Jaco fittings, black nylon screws, gaskets for the 6"OD tubes, irrigation mini gate valve (fits onto airline hose), 2 of 1.5" gate valves (non Spears FPT x FPT)
-----------------------------------------
I can also get:
brass check valves (either FPTxFPT or MPTxMPT)
mufflers (good for high aeration protein skimmers)
-----------------------------------------
I don't know what I have exactly. There's a lot of stuff here but I've put them all into a box. In any event, you can always let me know what you or other DIYs need and I can get them for you guys. Maybe the business should be tailored to this DIY industry. I can also cut out flanges for other sizes as well.

As for pricing, I don't think I have problems matching. Just let me know what you guys need.

[ 14 December 2001: Message edited by: Titus ]