|
|
|
#11
08-01-2003, 05:10 AM
|
||||
|
||||
go to your local welding supply store and ask for a co2 reg. washer. it should not come close to interfering with your threads.
__________________
Darin 
|
|
#12
08-05-2003, 07:10 PM
|
||||
|
||||
|
ok, got the washers and had another prob. When I was increasing the pressure on the tank via the black knob to 40psi ( it was the max on the right gauge) like they said there was a hissing sound, then a loud whinning sound as I approached the 40psi mark the gas was comming out of a hole on the reg behind the left dial I know it shouldn't be doing this, but any idea why it is? I am pretty sure I had the needle valve all the way open. The only thing I could think of was that the pressure was too high, but it said 40psi on the outside set of numbers on the right guage. Thanks.
Sean
|
|
#13
08-05-2003, 07:26 PM
|
|||||
|
|||||
|
Quote:
__________________
No matter what the morrow brings, inventors keep inventing things. ----------------------------------- Jonathan ----------------------------------- www.cakerybakery.ca
|
Linear Mode
