|
|
|
|
|
#1
06-05-2003, 03:58 PM
|
||||
|
||||
electrical genius's question deux
I have a 175 W M light that is flickering. it starts normally get to full brightness but then it pulses. I suspect it to be about 3-4 pulses per second. Has anyone had this problem before and more important does anyone know how to fix it?
thanks ross
__________________
take pictures, leave footprints 
|
|
#2
06-05-2003, 06:54 PM
|
||||
|
||||
|
It can happen if the wrong ballast is use on a bulb, but usually happens on older bulbs. Try turning the bulb slightly in the socket so as to change the position of the inner envelope of the bulb. This will usually do the trick.
__________________
-=Bryan=-
|
|
#3
06-06-2003, 01:40 AM
|
||||
|
||||
|
Actually the ballast is toast. In electonics there is a saying....every component contains a certain amount of smoke..and once you let all the smoke ...it's toast.
It let all the smoke out today   
__________________
take pictures, leave footprints
|
|
#4
06-06-2003, 03:07 AM
|
|||||
|
|||||
|
ahh good them problem solved and I didn;t have to think on this way to hot of a day.. was 32 degrees in the shade at 5 pm today.. suposed to be 4 degrees hotter tomorrow
 Steve
__________________
 *everything said above is just my opinion, and may or may not reflect the views of this BBS, its Operators, and its Members. If cornered on any “opinion” I post I will totally deny having ever said this in a Court of Law…Unless I am the right one*Some strive to be perfect.... I just strive.
|
Hybrid Mode
