|
|
|
|
|
#1
04-20-2013, 05:36 PM
|
|||||
|
|||||
DC pump mods for/with profilux
Well, after a brief discussion about this with Steve this morning, we figured it was time for a bit more DIY.
I will show first of all the mods done to the wp40, followed by the waveline pump(or in this case the attempt, but im pretty sure its all figured out already). I am using a P3 for control, with the base of a EVG card. With this, I have eliminated the need for the wp40 control and have complete control over the pumps with the profilux. Hoping to do the same with the waveline DC pumps. Please, keep the thread clean, I don't need it closed. Its here to be a help for everyone, I could also do this mod for the Apex as well. Ill post it here at a later date.
__________________
There's plenty of room for all God's creatures. Right next to the mashed potatoes. Last edited by The Codfather; 04-20-2013 at 05:38 PM. 
|
|
#2
04-20-2013, 05:42 PM
|
|||||
|
|||||
|
Wp40
For those that have been following the wp40 thread, this is not anything new.
Just a re-post. But there are a lot of similarities between the two, so thought I would include it.   
__________________
There's plenty of room for all God's creatures. Right next to the mashed potatoes.
|
|
#3
04-20-2013, 05:44 PM
|
|||||
|
|||||
|
DC waveline
Here is the waveline controller.
   
__________________
There's plenty of room for all God's creatures. Right next to the mashed potatoes.
|
|
#4
04-20-2013, 05:46 PM
|
|||||
|
|||||
|
Same??
Just looking at it, Id say they are very close to comparison.
I have the WP40 completed and running, so a few things need to be figured out. More to come. Again, please lets keep the thread a clean one. Thanks for looking, Bob
__________________
There's plenty of room for all God's creatures. Right next to the mashed potatoes.
|
|
#5
04-20-2013, 06:44 PM
|
|||||
|
|||||
|
EVG card for profilux
Consider this board cut in half.
The right hand side-110v The left hand side-low voltage. Right hand side.-Power comes in, splits to feed both AC/DC adapters. Upper left-to profilux Lower left-1-10v signals(or in the case of wp40 1-5v) 
__________________
There's plenty of room for all God's creatures. Right next to the mashed potatoes.
|
|
#6
04-20-2013, 06:48 PM
|
|||||
|
|||||
|
Harness for wp40
Here is a quick reference for the wiring.
 You can read it directly from the board.
__________________
There's plenty of room for all God's creatures. Right next to the mashed potatoes.
|
Hybrid Mode
