Drilling?

[BCWolfen]

I emptied my old 33Gal FW today to plumb it into my SW setup and discovered (as I had forgotten) that it had been previously drilled in the bottom. This hole has been covered over with a square piece of glass siliconed all along the bottom and along the four edges.

I'm wondering what my best options would be here.

Should I try to remove the piece? Is there a good way to do it? Or am I risking crack
ing the base where the hole is?

Or should I get a diamond bit for my dremel and drill through the 2nd piece using the existing hole as a guide?

Any tips?

[Invigor]

go at it with a razor..resilicone the original stuff if you feel you've wrecked the seal..since it's on the bottom you can use a ton of silicone without having to worry about it "looking pretty"

[BCWolfen]

The razor thing is really hard, I can't even seem to get the razor between the 2 pieces of glass. Even if I do get it, it will only go in as far as the razor will reach. So it won't be able to cut all the silicone.

[Johnny Reefer]

Would a knife work?

Cheers,

[StirCrazy]

Originally Posted by BCWolfen

The razor thing is really hard, I can't even seem to get the razor between the 2 pieces of glass. Even if I do get it, it will only go in as far as the razor will reach. So it won't be able to cut all the silicone.

try find a thin piano wire and make a couple handles for it and work it in there slowly.. should cut it off in no time

Steve

[AndyL]

home despots/rona/home hardware/totem etc sell a cable cutter in the tile aisle - works great for these types of projects.

Make sure you remove all the silicone where the bulkhead will sit - take your time, do it right, you don't want the leak.

Andy