|
Portal | PhotoPost Gallery | Register | Blogs | FAQ | Members List | Calendar | Search | Today's Posts | Mark Forums Read |
|
Thread Tools | Display Modes |
|
#1
|
|||||
|
|||||
LF: Stand fabricators
Anybody on here fabricates steel or wood stands ??
I am looking to build a stand that is 36 x 30 x 36 |
#2
|
||||
|
||||
Greg (The Grizz), he's located just north of Red Deer.
|
#3
|
||||
|
||||
I have built 3 stands following this template and calculations over at RC from RocketEngineer:
http://reefcentral.com/forums/showpo...71&postcount=1 (including the stand for my 7' long 210gal display) The template generates a cut list where you can cut everything before hand, and then just get to assembling!
__________________
Single System Setup: 210G SPS reef, 225G FOWLR, 72G water change, 50G frag, 120G sump. I promise a journal at some point! (anyone need some coral frags? I likely always have stuff that is frag-ready) |
#4
|
|||||
|
|||||
+1 on both accounts.
The Grizz does extremely precise and reliable metal work. If your going the wood direction, Craigs information is spot on. |
#5
|
||||
|
||||
I can design and get stands made in alberta or the lower mainland
|
#6
|
|||||
|
|||||
I build them. Pm me.
__________________
My 70 Gallon build: http://www.canreef.com/vbulletin/showthread.php?t=66478 My Mandarin Paradise: http://www.canreef.com/vbulletin/showthread.php?t=72762 I wonder... does anyone care enough to read signatures if you make them really small? I would not. I would probably moan and complain, read three words and swear once or twice. But since you made it this far, please rate my builds. |
#7
|
||||
|
||||
I am a ticketed welder/fitter/fabricator. Can help ya out if need be. Will charge for material and my time is worth a case o brews!
I understand grizz has experience with stands as well. Sent from my HTC Desire 601 using Tapatalk |
Thread Tools | |
Display Modes | |
|
|