|
|
|
#61
08-10-2004, 01:13 AM
|
|||||
|
|||||
Steve, the fan moves a lot of air around the corner of the room, which to me is more than enough. I didn't buy this with any instructions about installing a 19" fan 12 inches from the front of the chiller. I shouldn't have to use ANY fan to cool it, as far as I'm concerned.
John (J&L) mentioned they had this once with someone who had too ittle water flow thru the unit, but that doesn't seem to be my problem. I'll meausre the flow tonight.
__________________
Brad 
|
|
#62
08-10-2004, 01:45 AM
|
||||
|
||||
|
Brad,
I'm using the original fuse, probably 10A. I'll take a look later and let you know if its anything other. For water circulation I'm running a Mag12. I wonder if the fan is smaller in the newer units since you noted earlier that yours was fairly quiet. I'll see if I can read the numbers on the fan as well.
|
|
#64
08-10-2004, 01:47 AM
|
|||||
|
|||||
|
to little water flow or to much?.. hmm that could be, kinda makes sence in a round about way.. I'll see what I can dig up in my refrigeration book on that..
what are you using for a pump? after checking my application I am thinking I am only putting 300gph through mine max Steve
__________________
 *everything said above is just my opinion, and may or may not reflect the views of this BBS, its Operators, and its Members. If cornered on any “opinion” I post I will totally deny having ever said this in a Court of Law…Unless I am the right one*Some strive to be perfect.... I just strive.
|
|
#66
08-10-2004, 01:56 AM
|
|||||
|
|||||
|
Quote:
 Steve
__________________
*everything said above is just my opinion, and may or may not reflect the views of this BBS, its Operators, and its Members. If cornered on any “opinion” I post I will totally deny having ever said this in a Court of Law…Unless I am the right one*Some strive to be perfect.... I just strive.
|
|
#67
08-10-2004, 02:06 AM
|
|||||
|
|||||
|
OK, what pump is everyone running on their PCI chillers? It looks like mine isn't pumping the minimum required. Only about 135gph right now. I'm going to see what I can do about that.
__________________
Brad
|
|
#69
08-10-2004, 04:51 AM
|
|||||
|
|||||
|
Quote:
__________________
Brad
|
|
#70
08-10-2004, 05:08 AM
|
||||
|
||||
|
Hmmm.
3/4" ID tubing, going from the mag 7 in the sump to the chiller (about 2' run) then from the chiller to the UV unit (16-18" run) and then from the UV to the sump (2.5' run). I really didnt think my last post thru very well  I should measure the output of that.
|
Linear Mode
