#1
|
|||||
|
|||||
durso question
so I've setup a durso which seems to be handling the flow fine, no gurgling or up and downing, although the hole in the cap whistles, would it be ok to drill a slightly bigger hole to make the whistle go away or will that cause more bad than good?
__________________
a tout le monde, a tous les amis. je vous aime, je dois partir. |
#2
|
|||||
|
|||||
ive seen a mod all u do is stick a tube in it and put it down below so the whistle cant be heard
|
#3
|
|||||
|
|||||
YEs you can do this i had the same thing happen to mine on the 62 gal. My wife would say your tank is singing again .
So i just took off the cap from the durso and stuck a small tupperware cup in there and drilled a hole in it and worked like a charm. mike
__________________
180 starfire front, LPS, millipora Doesn't matter how much you have been reading until you take the plunge. You don't know as much as you think. |
#4
|
||||
|
||||
Hole
a slightly bigger hole, or a fitting for a few inches of line, or if in doubt try:
http://www.rl180reef.com/frames.htm ...Richard Durso himself
__________________
John its all about quality, not quantity..... ...when in doubt buy a Binford.... |