No one likes it when mom is unhappy.
Notme was the culprit.
One of the annoyances about Nano Cubes, is that the aquariums just aren't designed for a lot of equipment. I had to hack out the hood in a few places so the cords from the devices inside the back chambers could be run out of the aquarium.
The cords then need to be aligned and held in place. In the event one doesn't do this, the cords will shift and get pinched in the hood when it is closed. I had this happen with my NC12 a couple of times, and the hood cut through the protective coating on the cables leaving exposed wire. There is still a little positioning work still required inside the aquarium to ensure that everything lines up perfectly. I think zip ties should take care of that.
The cable holder on the far right of the top photo is just there to keep that cable shifted over a little: so that it doesn't creep out from behind the tank and become noticeable to viewers.