well i had the unit connected to the computer with the serial cable. i finally figured out how to setup my wireless network to accept computer to computer access in order to connect to the controller, i then followed the wlan/lan tutorial from the disc on all the steps, after that i setup the redirector. i assigned ip address and set the port to 10002. on the controller under communication i assigned the unit to use the router function, serial 2/WLAN and default to WLAN. when i disconnect the serial cable and try to then use the program to connect it cannot find the controller. i tried using a hyper terminal on computer and it does not locate the unit. i truly have no idea where to start from here.i hope this is enough info
|