Canreef Aquatics Bulletin Board  

Go Back   Canreef Aquatics Bulletin Board > Search Forums
Reload this Page Search Results
Portal PhotoPost Gallery Register Blogs FAQ Members List Calendar Today's Posts

Page 3 of 140 < 12 3 451353103 > Last »
Showing results 51 to 75 of 3487
Search took 0.07 seconds; generated 65 minute(s) ago. Search: Posts Made By: banditpowdercoat
Forum: Reef 03-12-2014, 09:12 PM
Replies: 6
Views: 1,814
Posted By banditpowdercoat
Those things don't put tap water into tank? I...

Those things don't put tap water into tank? I seen them but thought they were for FW tanks only?
Forum: Reef 03-12-2014, 05:55 PM
Replies: 8
Views: 1,691
Posted By banditpowdercoat
Wild!! Thats good to know. Thx. I wont be as...

Wild!! Thats good to know. Thx. I wont be as skeptical about them now
Forum: Reef 03-12-2014, 05:32 PM
Replies: 8
Views: 1,691
Posted By banditpowdercoat
I dunno if I would trust uniseals at bottom when...

I dunno if I would trust uniseals at bottom when full of water? I have similar setup with bulkheads and all is fine. Just had to put bulkhead up a little higher from bottom so it would flatten the...
Forum: Reef 03-12-2014, 05:07 PM
Replies: 6
Views: 1,814
Posted By banditpowdercoat
How to clean Sump?

OK, How am I gona clean my Sump? Getting a lot of detritus built up on my DSB section. But, Its too low to siphon. I think a MJ pump or anything will just suck up the sand and get clogged. How do...
Forum: Buy/Sell/Trade (Aquatics hardware related only) 03-10-2014, 03:01 AM
Replies: 4
Views: 1,273
Posted By banditpowdercoat
I have a bare no case Ballast (transformer and...

I have a bare no case Ballast (transformer and wires) and a Galaxy Dual Ballast with timer, if your interested
Forum: Nano Tank Talk 03-09-2014, 04:01 AM
Replies: 12
Views: 5,617
Posted By banditpowdercoat
My 45G came with a "Ikea" Stand. Laminate...

My 45G came with a "Ikea" Stand. Laminate covered Particle board. I even pulled the center support out to put a sump in. All was good. Had some spills in the sump, and it did swell a little but...
Forum: DIY 02-09-2014, 05:44 AM
Replies: 9
Views: 3,954
Posted By banditpowdercoat
build what? the controller interface for the WP...

build what? the controller interface for the WP to Apex? About $6. a $5.90 eithernet cable and 2 $0.05 10K ohm resistors. That is all.

Google WP40 Apex and you will find lots of how toos
Forum: DIY 02-09-2014, 05:02 AM
Replies: 9
Views: 3,954
Posted By banditpowdercoat
You can see my whole prog on reeftronic.net I...

You can see my whole prog on reeftronic.net I forgot Heres the link

http://www.reeftronics.net/dan-p/apex-program

My outlets are not all consecutive. Hard to follow a bit. But its there. ...
Forum: DIY 02-09-2014, 04:52 AM
Replies: 9
Views: 3,954
Posted By banditpowdercoat
I cant post my profile as I don't know how to...

I cant post my profile as I don't know how to copy it, but its pretty much the same as his, he copied that prof off someone else online just like I did I am sure. Found it on Manhattian reefs or...
Forum: DIY 02-09-2014, 03:58 AM
Replies: 9
Views: 3,954
Posted By banditpowdercoat
Did the same with my 2. And you don't need the...

Did the same with my 2. And you don't need the capacitor in there, Just 2 10K resistors. Also, 2 WP25 have been running off 1 of the power supplies just fine. I wired mine to 1 supply to minimize...
Forum: Buy/Sell/Trade (Aquatics hardware related only) 02-05-2014, 09:39 PM
Replies: 3
Views: 784
Posted By banditpowdercoat
I have a Milwalkee I don't use any more. Probe...

I have a Milwalkee I don't use any more. Probe is atleast 6 years old. But still reads the same as my Apex. I just keep it in tank to keep it moist etc.
Forum: JL Aquatics 01-31-2014, 04:35 PM
Replies: 12
Views: 3,901
Posted By banditpowdercoat
LMAO Nice try

LMAO Nice try
Forum: JL Aquatics 01-31-2014, 04:30 PM
Replies: 12
Views: 3,901
Posted By banditpowdercoat
Dang, I just tried and was like WTF!!! Then seen...

Dang, I just tried and was like WTF!!! Then seen this thread
Forum: Reef 01-30-2014, 03:02 AM
Replies: 15
Views: 3,303
Posted By banditpowdercoat
That's just it, I wasn't getting the flow needed...

That's just it, I wasn't getting the flow needed below the surface. AND, the amount of weir I lowered still allows some coast to coast overflow. But maybe 1/16" now with the wave, not the 3/8" it...
Forum: Reef 01-29-2014, 03:14 PM
Replies: 15
Views: 3,303
Posted By banditpowdercoat
Well I made some changes, I cut about 12" out of...

Well I made some changes, I cut about 12" out of the center of my Coast to Coast Weir. I have a plastic extension piece above the glass. I lowered this 12" piece about 3/4" and now the wave is...
Forum: Reef 01-28-2014, 04:48 PM
Replies: 15
Views: 3,303
Posted By banditpowdercoat
Now my conundrum. Tank level is fairly high. ...

Now my conundrum. Tank level is fairly high. Built it before I went with a wave. SO I have 1.5" static water height between my overflow and Eurobrace. I can lower it about 3/4" as I have a...
Forum: Reef 01-27-2014, 02:33 AM
Replies: 15
Views: 3,303
Posted By banditpowdercoat
My tank is 5'. Amd I think 2 WP25's isnt enough,...

My tank is 5'. Amd I think 2 WP25's isnt enough, but 2 40's might be to much at full? Not sure. I have them running off a Apex, not the Jebao controller. I might upgrade to 2 40's later. If I...
Forum: Reef 01-25-2014, 07:52 AM
Replies: 18
Views: 3,587
Posted By banditpowdercoat
Past 2 days, 3 15g waterchanges 10% 15g is all...

Past 2 days, 3 15g waterchanges 10% 15g is all I can make at one time. Removed almost all rock, freshwater scrub with toothbrush. Just pluged my ATO pump back in, and like a Boss I plugged it...
Forum: Reef 01-25-2014, 02:05 AM
Replies: 15
Views: 3,303
Posted By banditpowdercoat
Coast to coast overflow hampers wave?

So I've been playing with my WP-25's on my 150. Have one at either either end. Got a not bad wave, or so I thought. Today, doing some spot feeding and such, Sump return off, so the water level in...
Forum: Reef 01-24-2014, 09:35 PM
Replies: 18
Views: 3,587
Posted By banditpowdercoat
I think I need a new clean up crew. Mine has...

I think I need a new clean up crew. Mine has pretty much dissapeared. Prob gona make a call to JL today. Just don't know what to get anymore? I used to have lots of snails and a couple blue...
Forum: Reef 01-24-2014, 03:16 AM
Replies: 18
Views: 3,587
Posted By banditpowdercoat
To many Bio bad? I have 2 TLF reactor 2/3 full...

To many Bio bad? I have 2 TLF reactor 2/3 full for 150g display, 210g total volume
Forum: Reef 01-24-2014, 02:31 AM
Replies: 18
Views: 3,587
Posted By banditpowdercoat
Only using Biopellets

Only using Biopellets
Forum: Reef 01-24-2014, 02:21 AM
Replies: 18
Views: 3,587
Posted By banditpowdercoat
I do have a GHA issue too, but mostly at the...

I do have a GHA issue too, but mostly at the upper levels of the tank, like overflow rim
Forum: Reef 01-24-2014, 01:45 AM
Replies: 18
Views: 3,587
Posted By banditpowdercoat
Sorry pic was too big had to resize Ya it...

Sorry pic was too big had to resize
Ya it blows off mostly with a power head. Looks stringy like kinda tho
...
Forum: Reef 01-24-2014, 01:16 AM
Replies: 18
Views: 3,587
Posted By banditpowdercoat
Is this Diatoms?

My tank has a wall to wall outbreak of this. Not sure if it's lighting or water> Params seem all OK. Well Sg, Ca, Mg, Ak was really high tho. Just did a W/C

Help please, Blew as much as I...
Showing results 51 to 75 of 3487
Page 3 of 140 < 12 3 451353103 > Last »

 
Forum Jump

All times are GMT. The time now is 09:39 AM.

Contact Us - Canreef Aquatics - Archive - Top

Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.