Canreef Aquatics Bulletin Board

Page 3 of 5

Show 40 post(s) from this thread on one page

Canreef Aquatics Bulletin Board (http://www.canreef.com/vbulletin/index.php)

- Filtration and Skimmer Specific (http://www.canreef.com/vbulletin/forumdisplay.php?f=174)

- - Vertex omega 130 (http://www.canreef.com/vbulletin/showthread.php?t=103181)

Ryanerickson

12-24-2013 03:22 AM

Sorry viles

Chase31

12-24-2013 03:23 AM

I thinks that's reef booster should have mentioned reef booster wasn't dosed

BlueTang<3

12-24-2013 04:08 AM

Quote:

Originally Posted by Chase31 (Post 868616)

So finally got a chance to get home and change my carbon and 10 mins later it was low in the chamber. As I suspected the bubbles were 2-3 inches above the bubble plate. As before they were below. Well I started adjusting it and came back after 20 mins and it was below the plate and overflowing. So should I change my carbon again? I have a dual brs reactor and filled them both up about half way, carbons only been in for an hour or so at this point. Also like to add that I dosed my prodibio today before the carbon

The skimmer would have lost the head because of you in the tank, oils from you skin will cause the skimmer to drop down.

BlueTang<3

12-24-2013 04:12 AM

Have you tried to pull the hose off the bottom of the silencer, its not uncommon for shipping stryfoam to partially block the air intake causing to bubble over. Are you using ro water? I was told with my first bubble king that I needed ro water as so as I switched it stoped bubbling over.

Chase31

12-24-2013 04:19 AM

Always used ro/DI on my tanks like I said the bubbles were above the plate and it was creating head, I will check the air intake but I did a pretty thuro check when I got it, didn't put my hands in the water when it started to skim as normal. Sorta baffled as it was skimming like I wanted it to for maybe 15-20 mins then started overflowing again. Still overflowing

Chase31

12-24-2013 04:21 AM

http://img.tapatalk.com/d/13/12/24/8a9aru5e.jpg

This is what I mean by bubbles below the bubble plate

Chase31

12-24-2013 05:07 AM

Also have lots of bubbles out of the riser T

BlueTang<3

12-24-2013 12:50 PM

Silly question but looking closer at the pics I see you have a red hose off the second num on the pump volute, did it come with that or did u add that where is it going to ?

All my skimmers from vertex/ royal exclusive have had a cap on that or it's been opened under the water.

Chase31

12-25-2013 04:34 AM

The red hose is for ozone and came with it, the top has a black cap on it. It has gotten better and skimmed for a bit then lost it's head when cleaned some algea with a toothbrush.

reefwars

12-25-2013 02:56 PM

Anytime you put your hand in the water the head will collapse , most good skimmers will do this

Try this

Set your omega water level really low walk away for two days this will dirty up the neck then slowly raise it the omegas are touchy so msll adjustments and allow it to settle for 15 mins before touching it sgain remember don't put your hand in the water

Feeding and cleaning are they same;)

All times are GMT. The time now is 01:10 AM.

Page 3 of 5

Show 40 post(s) from this thread on one page