View Full Version : Anyone have a router??

08-18-2008, 06:02 PM
I don't have access to a router anymore, and I need to carve out some teeth for overflows in some acrylic. Anyone have a router I could borrow, or who would be willing to do it for a case of beer or coral frag or ??? There is only about 12" of teeth I need done. :D

08-18-2008, 10:07 PM
You can use a table saw thats what I use just mark and keep moving your fence over. You won't end up with the round hole on the bottom but square works just as well.

08-18-2008, 10:26 PM
I don't have a table saw either. ;) But thanks for the idea! :)

08-18-2008, 10:37 PM
Send me down the piece of acrylic, we can do the teeth for you.

All the best.

Ocean Aquatics.

08-19-2008, 12:41 AM
Hey, that would be great, and thanks for the offer! But...the acrylic only cost me $10, and shipping would prob be $20 by the time I got it back. I may be heading down to the lower mainland in the next month, and if my procrastinating butt hasn't set the tank up by then, I will bring the acrylic with me. :D

08-24-2008, 09:04 PM
Anyone? I'll drive anywhere from Vernon to Penticton...

08-24-2008, 09:57 PM
I got one here, w/ a acryllic bit in it

08-24-2008, 11:34 PM
Check your PMs. :)